|
|  | Millermatic 350P MIG Welder 907300Millermatic 350P MIG Welder 907300 detail  Click for larger image  Click for larger image 
Millermatic® 350P MIG Welder 907300
The Millermatic® 350P MIG Welder is the first single or three-phase power Millermatic that welds material from 22 gauge to 1/2 in thick in a single pass. Perfect for fabrication, manufacturing, maintenance and repairNow, on top of legendary Millermatic® simplicity, the welder inverter technology and pulsed-MIG welding capability. That opens the door to even better weld quality and improved productivity on all metals, including thin-gauge aluminum and stainless steel.
Processes
MIG (GMAW)
Pulsed MIG (GMAW-P)
Flux Cored (FCAW)
Applications
Industrial Applications
Fabrication
Maintenance and Repair
Manufacturing
Features
Built-in Pulsed MIG programs
.035 and .045 in (0.9 and 1.2 mm)
for mild or stainless steel.
.035 and .047 in (0.9 and 1.2 mm)
for 4000 and 5000 series aluminum.
.045 in (1.2 mm) for metal core.
All programmed information is stored
for MIG, push-pull and spool guns,
and is restored after each power up.
1- or 3-phase input power with line
voltage compensation for constant
output even with fluctuations to the
input power.
Aluminum Pulse Hot Start™
automatically provides more arc
power to eliminate a “cold start”
that is inherent with aluminum starts.
Superior aluminum performance.
Direct connection for optional XR™
push-pull guns or Spoolmatic®
spool gun. With Gun-On-Demand,
simply pull the trigger for the gun to
be used and you’re ready to weld.
Fan-On-Demand cooling only
operates when needed, reducing
power consumption and
contaminants inside the unit.
Industrial, 4-roll wire drive system
features two easy-to-set, scaled,
tension adjustments and quick-change
reversible drive rolls for .035 and
.045 in (0.9 and 1.2 mm) wire.
Special features
Run-in adjustment for MIG, push-pull and spool guns.
Built-in 2-minute spot timer.
Pre-flow and post-flow adjustment.
View actual welding amperage/voltage during
welding, and 5 seconds after arc has shutoff.
SharpArc™ controls welding arc cone width in
pulsed MIG welding mode.
Inductance control customizes weld out put
characteristics in MIG welding mode.
Internal timers
Adjustable crater feature optimizes crater size
for steel, stainless, aluminum and metal-core
applications.
Crater time delay allows
deactivation of crater feature for
tack or small welds.
Specs
Comes complete with:
Millermatic® 350P MIG Welding Power Source
Bernard Q300 MIG Gun
Industrial power cord (without plug) for
single- or three-phase
Work cable with clamp
Factory-installed gas solenoid
Argon mix regulator/flow meter
Factory-installed, low-mounted running
gear/cylinder rack
Drive rolls and contact tips
Free standard ground shipping within contiguous U.S.
|
|
|
