By Dave from Quebec City, Canada on April 25, 2015
Will this work with my Thermal Dynamics PCH/M-35 torch on my PAK-Master 50 plasma cutter?
By Customer Service on April 28, 2015
Answer:The Miller Plasma Standoff Roller Guide 253054 will not work properly on your Thermal Dynamics torch
By Rick from Oxford,Al on August 8, 2013
Will this standoff guide work with Hobart 500i plasma cutter? Thanks
By Customer Service on August 9, 2013
Answer:Miller Plasma Standoff Roller Guide 253054 will not work with a Hobart 500i plasma cutter HP-50 torch.
By travis from south dakota on July 15, 2013
would this work on hypertherm torches?
By Customer Service on July 18, 2013
Answer:We have contacted Miller regarding your question. They are not certain that the Miller Plasma Standoff Roller Guide 253054 will work on a Hypertherm plasma torch.. The Standoff Roller Guide does come with 2 different size adapters but Miller cannot verify if the 253054 will work correcty
By mike from Orlando,FL on May 4, 2013
will this work on my Miller plazma cutter extream 375?
By Customer Service on May 6, 2013
Answer:Yes the Miller Plasma Standoff Roller Guide 253054 will work with a Miller 375 extreme
By Dave from Wisconsin Rapids, WI on November 12, 2013
Will this guide and the miller cutting guide work with the XT 60 torch shipped with the Miller Spectrum 875
By Customer Service on November 12, 2013
Answer:Miller advises that the Miller Plasma Standoff Roller Guide 253054 and the Miller Plasma Cutting Guide 253055 will work with the XT 60 torch
By Kathy from PA on July 23, 2013
Will this guide work on a Hobart 250 CI Plasma?
By Customer Service on July 25, 2013
Answer:Miller Plasma Standoff Roller Guide 253054 will work with the Hobart 250ci.
By Richard Jennings from Smithille Tennessee on July 29, 2013
will this cutting guide work with a Nothern Indurstial plasma 375 cutter?
By Customer Service on July 29, 2013
Answer:We do not sell the Northern line of plasma cutters and cannot determine whether the Miller Plasma Standoff Roller Guide 253054 will work with the Northern 375
By Raul from Alice, Texas on June 6, 2014
I purchased this roller guide from you and received it yesterday, which in fact that was quick delivery and I thank you for that but my concern is it does not quite fit on my torch like viewed on the picture. My torch is an XT40. I tried installing it with the larger ring that it is equipped with but it does not sit flush like it shows on the picture. What do you recommend for this problem? Since it does not sit flush, the torch will not be close enough to the work piece to get the spark it requires to start cutting.
By Customer Service on June 9, 2014
Answer:In order to install the Miller Plasma Standoff Roller Guide 253054 on a XT40 torch you will need to remove the lower snap ring and remove the standard bushing. Install the larger bushing and the adjust the wheel height so that you have the correct gap between the work piece and the torch tip