By Bill Johnson from Fort stockton Texas 79735 on October 22, 2015
Does cyberweld have any welding cable #1 or 1|0 made by Miller or Hobart, which I can buy by the foot. I would like to use this towards the $500 rebate on the Miller bobcat 250.
By Customer Service on October 26, 2015
Answer:We do not sell any welding cables that are made by Miller or Hobart that can be purchased by the foot.
By Larr from Princeton, NC on July 25, 2012
is the male plugs on ends of cable, identical to original plugs, which have to be inserted then twisted to get locked in place? and is there rubber covering to go over metal din plugs, thanks
By Customer Service on July 25, 2012
Answer:This is the same cable set that is supplied with the Miller Maxstar 150 series welders. It does have 25mm male dinse twist-lock connectors with rubber covers installed.
By Matt from Vermilion, Ohio on November 16, 2015
I have an old airco 110 volt machine will these cables work with it it base the small plug adapter like these. Just want to make sure they are right before I order them
By Customer Service on November 16, 2015
Answer:The Miller Welding Cable Set - No. 4, 10 ft. 208505 has 25 mm Dinse connectors as cable ends.. We are not that familiar with Airco welding machines but if your machine is old as you have indicted then these cables will probably not work since the use of Dinse style connectors did not come into fashion until fairly recently in the USA.
By Jim Kish from NC on March 17, 2015
Do you sell this 10' ground clamp on its own?
By Customer Service on March 17, 2015
Answer:We do not sell the ground cable that comes in the Miller Welding Cable Set - No. 4, 10 ft. 208505 separately.
By Shane Cartrette from Chadbourn, North Carolina on May 20, 2015
Is there adaptors made to adapt these up from 25mm to 50mm. I have an older miller 200 machine and thought these were the right cables and ordered them awhile back just found out they will not work. The ends are to small for my machine.
By Customer Service on May 21, 2015
Answer:We do not off an 50mm dinse to 25mm dinse adapter which will allow you to connect the Miller Welding Cable Set - No. 4, 10 ft. 208505 to your older Miller machine.
By david from newburyport ma on October 10, 2013
do these cables fit the miller 145 dx welder and do the cables come in longer than 10 ft length ?
By Customer Service on October 14, 2013
Answer:The Miller Welding Cable Set - No. 4, 10 ft. 208505 will not work with the Miller 145 dx.. The Hobart Welding Cable Set - No. 4, 20 ft. 193067 will work and it has 20 ft cables.. If you need cables longer than 20ft we offer the Hobart Welding Cable Set - No. 2, 50 ft. 195195 which is 50ft long..