Thermal Arc Bottom Drive Roll - V Groove .023-.035 407002-002

5.0
Rated 5.0 out of 5 stars
1 Review

Code: 407002-002

1 1

Cyberweld Price $21.95
Cyberweld Price $21.95
Mfg Industrial Price: $22.80
(You Save $0.85)
-
+
WARNING: Cancer and Reproductive Harm - P65Warnings.ca.gov
FAST & FREE SHIPPING On All Orders Over $99


Thermal Arc® Bottom V Groove Drive Roll - .023-.035 407002-002

Genuine Thermal Arc® V Groove bottom drive roll for feeding .023-.035 diameter solid or flux-cored welding wire. Designed specifically for your Thermal Arc® Fabricator® 252i welder. Use this drive roll to feed hard, solid MIG wire and flux-cored welding wire.

Features
  • V Groove for .023-.035 solid & flux-cored welding wire
  • Fits Thermal Arc® Fabricator® 252i multiprocess welders.

    NOTE: This is a single, bottom drive roll only and must be used with a bottom drive roll - sold separately.

    • Thermal Arc Top Drive Roll - Flat .023-.045 407002-001

    Thermal Arc Top Drive Roll - Flat .023-.045 407002-001

    $22.45
    Lowest Internet Price
    Mfg Industrial Price: $23.33
    $22.45
    You Save $0.88

    Genuine Thermal Arc® top drive roll for feeding .023-.045 diameter solid & .045 flux-cored wire. For use with Fabricator® 252i.

    Thermal Arc Top Drive Roll - Flat Knurled .030-.035 375832

    5.0
    Rated 5.0 out of 5 stars
    2 Reviews
    $33.10
    Lowest Internet Price
    Mfg Industrial Price: $33.10
    $33.10
    You Save $0.00

    Genuine Thermal Arc® top knurled drive roll for feeding .030-.035 diameter flux-cored welding wire. For use with Fabricator® 252i.

    5.0
    Rated 5.0 out of 5 stars
    Based on 1 review
    Total 5 star reviews: 1 Total 4 star reviews: 0 Total 3 star reviews: 0 Total 2 star reviews: 0 Total 1 star reviews: 0
    Write a Review (Opens in a new window)
    1 review
    • P
      pfausette
      Verified Buyer
      I recommend this product
      Rated 5 out of 5 stars
      6 years ago
      ESAB 252i comes with one of these.

      The Fabricator I bought did not list this as coming with the welder so I bought this separately. I guess I will have a spare. The wheel is marked for .06-.08mm but not which side is which. When you drive .06mm wire, you HAVE to change over to the .06mm wire output guide or the wire will kink up and bind causing erratic feeding.

      Was this helpful?
    Reviews LoadedReviews Added