By doyle fain from jasper tex. on November 13, 2012
can i get a stright torch and a remote start and stop switch w/ this unit and what would be added cost
By Customer Service on November 15, 2012
Answer:We sell the Thermal Dynamics Cutmaster 102 Plasma Cutter models only with hand held torches..
By Paul from Murfreesboro, TN on March 13, 2013
Is this unit suitable for cutting thinner material, such as 1/2"?
By Customer Service on March 19, 2013
Answer:Thermal Dynamics Cutmaster 102 Plasma Cutter 1-1330-1 can cut 1/2 in. with no problem.
By Rodrigo Arana from Los Angeles, California on April 30, 2013
Dear Sirs: I need to know if I can plug this Cutmaster 102 in 400 volt 3 phase 50 hz?
Thank you for your answer
By Customer Service on May 2, 2013
Answer:The Thermal Dynamics Cutmaster 102 Plasma Cutter will run on the flowing voltages
Input Voltage 208V, 230-460V, 1/3 ph,
400V, 3 ph, 50 Hz
600V, 3 ph, 50/60 Hz
By victor from British Columbia Vancouver on May 14, 2013
i have a trail blazer newest model 12,000w can i operate the thermal dynamics 102 plasma cutter,or is the miller spectrum 875 autoline the biggest i can operate,is there any other that would do
By Customer Service on May 15, 2013
Answer:Thermal Dynamics advises that the Thermal Dynamics Cutmaster 102 Plasma Cutter 1-1330-1 will require 22kw to operate properly and it will not work on your Miller Trailblazer.. The Miller Spectrum 875 requires only 9.8 kw and will run off of the trailblazer