Hobart low profile welder/P-Cutter cart
October 28, 2020
Overall a great cart. This low profile cart is also great when space is tight, &/ or for possibly storing welder, or plasma cutter under a work-bench, & will fit under most when used with a 60 C.F. Cylinder/Bottle, which anything much bigger wouldn't be advisable due to the cylinder being harnessed insufficiency.
I personally bought this for the reasons I mentioned above. My Tig welder cart is much bigger, because it needed a big Argon Cylinder, & to hold a lot of things, filler rods, consumables, etc etc. Then for my Plasma Cutter I bought a similar yellow low profile cart to fit under my work bench for space. I just bought a MIG welder & wanted to also put it under my work bench, so I bought this black cart.
These carts are great for a Mig or P.C. where you don't need to necessarily store a lot on the carts, & both can fit under my work bench.
**The only issue, & a small little one for someone like myself, is that the screws holes aren't the best tapped. So i would buy some, 1/2" inch length self tapping flat top screws, & tap both upper & lower tiers flat panels to the frame, on each left & right side, for added stability.
This is far less complicated than it may sound. Just add a self tapping screw to each corner & the middle of the flat panels, along with the provided screws in provided screw holes.
Even with this small thing, this cart is completely worth it. As with any of these carts, etc etc, this does happen, sometimes even on the more expensive carts.
But doing this will ensure a study cart years of reliability.