Miller WC115A Weld Control with Contactor 137546011
Designed primarily for CC/DC power sources. It can also be used with CV power sources or DC engine drives supplying 115 VAC. When used with a CC source, the control circuit functions in a voltage-sensing mode. Includes contactor. Use with Spoolmatic® 15A & Spoolmatic® 30A.
This item ships Free via standard ground shipping within contiguous U.S.
Miller WC115A Weld Control with Contactor 137546011 can be used with the Trailblazer but it already has a built in contactor so, Miller recommends you just the Miller WC-24 Weld Control 137549. Use with Spoolmatic® 15A & Spoolmatic® 30A.
THIS CAN BE USED WITH THE BOBCAT 250 WITH THE 130831 SPOOLGUN DO U NEED ANY GAS / ARGON TO COMPLETE THE SETUP
The Miller WC115A Weld Control with Contactor 137546011 must be used with the 30A 130831 SPOOLGUN on a Bobcat.. If you are planning to weld aluminum with this set up you will need argon gas and a flow regulator.
How well does this item work for a Lincoln or Miller CC DC output generator unit without CV tap?
The Miller WC115A Weld Control with Contactor 137546011 can be used on a CC power source. In order to do this an internal jumper connection must be re-positioned.. It will not work as well on CC as it will on CV and weld will always be in spray transfer and may not work well on thin gauge material
can i use this to hook up a spoolgun to my bobcat 250 and work efficiently
You did not indicate which model of spoolgun you plan to use with your bobcat.. It you are going to use a Miller 30A or 15A spoolgun you will need the Miller WC115A Weld Control with Contactor 137546011. If your going to use the Spoolmate 3035 spoolgun you will need the SG100C control..The spoolguns will operate properly